--- diag-ether/pci-config.c.org	2004-02-22 22:13:59.000000000 +0000
+++ diag-ether/pci-config.c	2004-02-22 22:15:14.000000000 +0000
@@ -28,33 +28,32 @@
 static char *usage_msg =
 "Usage: pci-config [-aDfSvVW] [-# <device_index>]\n";
 
-static char *long_usage_msg ="
-
-  This program shows the contents of PCI configuration space.
-  It reads the hardware registers, and thus must be run as 'root'.
-
-  Running this program with no options shows the installed PCI devices.
-  Each line is prefixed by its index which may be used with -#<index>
-  e.g. \"pci-config -#3\" to specify the device to operate on.
-
-  Commonly use options are
-  -# <device-index>         Operate only on DEVICE-INDEX e.g  -#3
-
-  The operations on the selected device are
-  -a  --show-addresses   Show PCI address registers.
-  -S --sleep             Put device to sleep (ACPI D3 state)
-  -W --wake              Wake a sleeping device (ACPI D0 state)
-
-  Less commonly used options are
-  -B <bus>  --bus <bus>      Show only devices on BUS.
-  -A <addr> --set-addresses  Set PCI address register 1 to the ADDR.
-  -D  --debug                Show details of operations
-  -f  --force                Override checks and perform the operation
-  -u  --usage                Show this long usage message
-  -v  --verbose              Verbose mode
-  -V  --version              Display this program's version information
-
-";
+static char *long_usage_msg =
+"\n"
+"  This program shows the contents of PCI configuration space.\n"
+"  It reads the hardware registers, and thus must be run as 'root'.\n"
+"\n"
+"  Running this program with no options shows the installed PCI devices.\n"
+"  Each line is prefixed by its index which may be used with -#<index>\n"
+"  e.g. \"pci-config -#3\" to specify the device to operate on.\n"
+"\n"
+"  Commonly use options are\n"
+"  -# <device-index>         Operate only on DEVICE-INDEX e.g  -#3\n"
+"\n"
+"  The operations on the selected device are\n"
+"  -a  --show-addresses   Show PCI address registers.\n"
+"  -S --sleep             Put device to sleep (ACPI D3 state)\n"
+"  -W --wake              Wake a sleeping device (ACPI D0 state)\n"
+"\n"
+"  Less commonly used options are\n"
+"  -B <bus>  --bus <bus>      Show only devices on BUS.\n"
+"  -A <addr> --set-addresses  Set PCI address register 1 to the ADDR.\n"
+"  -D  --debug                Show details of operations\n"
+"  -f  --force                Override checks and perform the operation\n"
+"  -u  --usage                Show this long usage message\n"
+"  -v  --verbose              Verbose mode\n"
+"  -V  --version              Display this program's version information\n"
+"\n";
 
 #include <unistd.h>
 #include <stdio.h>